Toho-electronics TTM200 Bedienungsanleitung PDF herunterladen (Seite 80)

48-7009-E 5-10

② Start using the function key

Set the function key function to the AT start/stop function as the first step.

★

☆

For constant value run mode screen:

PV value (present value)

SV value (target value)

Hold MODE key pressed for 2 seconds.

Input 1 setting screen

Each set screen

Each setting mode

Press the ▲ key twice. Press it, however, once for TTM-204.

Key function setting screen

Press MODE key.

S03-1 Function key 1 function setting screen

Each set screen

Each setting mode

* The function key functions are set in this screen.

For content of key functions, see the function key function assignment table on page 4-20.

* The number displayed in the screen is coincident with that listed in the assignment table.

* Use the ▲/▼ key for setting the numbers.

* At factory shipment, “00: no function” is set.

* Set the items as follows: ★ = time period in which the function key is pressed and ☆ =

3 (AT start/stop function).

* Use the MODE key to move the screen for the setting screen to set the function keys 2 to 5.

The screens change in sequence each time when the MODE key is pressed.

(Note that only the function key 1 is available for TTM-204.)

* With the above operation, the function key (FUNC) is set to the AT start/stop function key.

* AT starts and stops by pressing the function key (FUNC) in the run mode screen.

In addition, AT stops when the ▲/▼ key is pressed during AT being effective.

* During auto-tuning, the target value and “At” is alternately displayed for SV (red).

* Upon completion of auto-tuning, the target value is displayed.

* Any function key is settable for the AT start/stop function, except on the model TTM-204.

* Holding the MODE key pressed for 2 seconds moves each setting screen to the run mode screen.

* In about 2 minutes, each setting screen (or any setting screen) automatically moves back to the run mode screen.

Hold MODE key pressed for 2 seconds.

For program run mode screen:

PV value (present value)

SV value (PRoG)

Hold MODE key pressed for 2 seconds.

Setting mode is the same as that for Hereinafter,

to the input 1 setting screen similarly to that for

the constant value run mode

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 263 264

Kommentare zu diesen Handbüchern

Keine Kommentare

Toho-electronics TTM200 Bedienungsanleitung Seite 80

Kommentare zu diesen Handbüchern